Viewing 1 to 4 (4 Total) Bolo versus Crowquill Avon |
|
---|---|
PeachyTotal Posts: 46
Joined: January 24, 2019
|
I have seen a lot of results whereby winning weights, or near winning weights, have come via the Bolo.
Tags:
Posted on February 25, 2020 at 6:43 PM
|
Johnny_CareTotal Posts: 407
Joined: June 10, 2015
|
Re: Bolo versus Crowquill AvonCrowquill Avons were traditionally made from balsa, whereas I'm guessing the modern bolos are foam. Foam doesn't take on water and doesn't vary in density, so a batch of floats would be identical, with the balsa ones varying. Most of the bolos also have wire stems, so they'd be steady in a flow, just like a wire stemmed stick float.
Posted on February 25, 2020 at 8:27 PM
|
mickgroveTotal Posts: 107
Joined: June 2, 2015
|
Re: Bolo versus Crowquill AvonHi - for obvious reasons I tend to find I am fishing deeper water or deeper swims in winter and always prefer float if possible, unless I am after barbel. I have a very simple set up which is a hybrid of lots of other methods, but it is great in deep steady swims and I usually catch well if the fish are there and feeding. I use a 17 foot float rod with an avon style float, with a wire stem, taking between 2g and 3g. Most of the weight is an olivet about three feet from hook to get bait down quickly. Have a micro swivel to attach hook length with a few small shot and droppers below oilvet. Bites are very positive and easy to hit with long rod. 17 foot rod allows you to fish in up to about 12 feet quite well. If swim is not too deep I may get away with 15 foot rod set up. Doubt I'll be using this rig any time soon though on the severn.......
Posted on February 26, 2020 at 1:37 PM
|
Robhol1Total Posts: 198
Joined: May 7, 2016
|
Re: Bolo versus Crowquill AvonBest rod I’ve bought is my 17ft float rod,the float seems pretty irrelevant as long as it’s heavy enough for the swim you are fishing ,I find you get a better presentation with the extra length while the rivers are high I’ve had a bit of success with a flat float and a small in line feeder on the pole.
Posted on February 26, 2020 at 5:16 PM
|